here's one night of crazyness don't stare at it too long... made using rhino but can easily be done in 3dengrave
using a tapered bit you could mill this.... finishing cut ...no need to rough cut then finish
spirals
Moderator: ToddMichael
funn
Hope I'm not the only one around here havin some fun!
the isocurve command is fun to play with..I misspelled "create" on #1
the isocurve command is fun to play with..I misspelled "create" on #1
- Attachments
-
- oval twist1.jpg (35.5 KiB) Viewed 4542 times
-
- oval twist.jpg (37.7 KiB) Viewed 4542 times
- jeff dunnington
- Site Admin
- Posts: 1622
- Joined: Tue Feb 24, 2004 1:24 pm
- Location: Houston, Tx
- Contact:
curve
not yet I'm still thinking about how I'd go about milling it maybe using a solid rod of wax?.. anyone want to try?
I tried to send the zipped stl file 19mb.. is there a way to reduce the file size more ...also a window came up saying "no post mode specified"so it would not load same window came up when I tried to send the rhino file (3dm)
I tried to send the zipped stl file 19mb.. is there a way to reduce the file size more ...also a window came up saying "no post mode specified"so it would not load same window came up when I tried to send the rhino file (3dm)