here's something I'm playing with ..creating 3d's from photo's.(the original photo is on the left)..the 3d file from the photo was imported into rhino as an obj file (I could have tilted it a lillte bit more) exported as an stl then milled on the mdx14 (one pass cutting x only) using tapered ball end .25mm 10 deg bit apx 20 min milling time... as you can see I should have tilted the model file more in rhino as right now budda is lookin up instead of straight on...my bad!
re-did it this time with more 'tilt' now you can see his 'toes'...
3d image from photograph
Moderator: ToddMichael
3d image from photograph
- Attachments
-
- BUDDA1.JPG (150.77 KiB) Viewed 10654 times
-
- pdnt.JPG (43.28 KiB) Viewed 10651 times
rhino4 and 5, rhino gold, hypershot, vector magic, next engine, cadwax ring builder, tsplines