Post pictures of your finished work!

Moderator: ToddMichael

Post Reply
User avatar
Posts: 268
Joined: Tue Aug 24, 2004 3:53 am
Location: gibson city illinois


Post by frog113 » Sat Nov 20, 2004 4:33 am

here is a pic of a T/T pend to duplicate the earring on the left
took a pic of the earring and used the bmp as a guide only
then used the freehand tool in 3d to match the outline....just used a rectangle for the base of the head (set properties to size of stone)
deleted the bmp and milled
91canary~dup2.JPG (195.25 KiB) Viewed 3532 times

User avatar
Posts: 188
Joined: Wed Feb 25, 2004 12:31 pm
Location: North Wilkesboro NC

Nice Work

Post by JewelryDoctor » Sat Nov 20, 2004 9:37 am

Imaganation is the mother of all invention. Larry you are really beginning to see what the mill can do. Very nice work.


Posts: 861
Joined: Sun May 30, 2004 8:12 am
Location: Waco, Texas

Post by Jwlrymkr » Sat Nov 20, 2004 10:15 am

Great job!
That would've been a b!tch to run rubber mold, inject, and then cut out in wax where all the stones were. Not to mention the shrinkage factor.
Great work!

User avatar
jeff dunnington
Site Admin
Posts: 1622
Joined: Tue Feb 24, 2004 1:24 pm
Location: Houston, Tx

Post by jeff dunnington » Sun Nov 21, 2004 9:55 am

Nice work Larry. Did you mill the back with the air lines separate?
Last edited by jeff dunnington on Sun Nov 21, 2004 4:56 pm, edited 1 time in total.

User avatar
Colin Creed
Senior Miller
Posts: 819
Joined: Tue Jul 20, 2004 2:57 am
Location: Berwick, Victoria, Australia

Nice Job

Post by Colin Creed » Sun Nov 21, 2004 4:47 pm

Hi Larry,

Nice looking piece, Well done!

regards Colin

Post Reply