Modela 4 question
Moderator: ToddMichael
Modela 4 question
I am doing a one side project. How do i set the 'model top edge depth" in Modela 4? My wax is 5.5 mm deep , the model is 4.4mm deep . Do I subtract the numbers and enter 1.1 for the model top edge depth in the z direction? Thanks.
just mill it and you will have apx 1mm left over on the bottom section or you can enter your numbers as posted ..make sure you have a sacrifical base down if you do.... or you will hit the table with your bit ....
rhino4 and 5, rhino gold, hypershot, vector magic, next engine, cadwax ring builder, tsplines