Hey everyone, I got my mill last week and I am so excited to use it. I am, however, a full time student as well as my duties here at the shop so getting into it has been difficult. I am so stoked to start though and look forward to all the insight I can get here. If there are any starting tips anyone wants to give that would be awesome and most appreciated. Thanks everyone,
Jeff Bowlby.
Main St. Jewelers, Klamath Falls, Oregon.
New guy here!
Moderator: ToddMichael
- jeff dunnington
- Site Admin
- Posts: 1622
- Joined: Tue Feb 24, 2004 1:24 pm
- Location: Houston, Tx
- Contact:
Hi Jeff
Welcome to the club. Best tip I can pass on would be to stay abreast of with the forum, look at as may 3dengrave files that are posted hear and check out all the Highlight post at this link http://www.3dwaxmill.com/tools-tips.html
If you have questions please ask no matter how insignificant you think it may be. You will get an answer.
Hope to see your work in the gallery.
Welcome to the club. Best tip I can pass on would be to stay abreast of with the forum, look at as may 3dengrave files that are posted hear and check out all the Highlight post at this link http://www.3dwaxmill.com/tools-tips.html
If you have questions please ask no matter how insignificant you think it may be. You will get an answer.
Hope to see your work in the gallery.
- Colin Creed
- Senior Miller
- Posts: 819
- Joined: Tue Jul 20, 2004 2:57 am
- Location: Berwick, Victoria, Australia
- Contact: