milling a ring with a word

Welcome to our community. Please introduce yourself.

Moderator: ToddMichael

martindiamonds
Posts: 17
Joined: Fri Feb 18, 2011 2:56 pm
Location: Chicago
Contact:

milling a ring with a word

Postby martindiamonds » Wed Aug 15, 2012 7:53 am

Im sure this is simple but I am trying to mill a ring with the word "breathe" and everytime I mill it the word comes out backwards.
What am I doing wrong?
Attachments
breathe.JPG
breathe.JPG (81.45 KiB) Viewed 1402 times

User avatar
ToddMichael
Posts: 636
Joined: Sat Jun 21, 2008 11:36 am
Location: Detroit, MI
Contact:

Postby ToddMichael » Wed Aug 15, 2012 10:33 am

Martin;

I am not sure of the reason, but you create the design in 3dEngrave, then mirror the design, then re raise, and export the DXF.

Because it flips it going from 3Dengrave to Modela. Trust me it works, also remember if you doing a design that has a specific direction that is needs to go in, right hand, left hand ect.

I delivered a custom two tone band, that was supposed to be an exact match to her wedding band they bought. I forgot to mirror the design, before exporting the dxf, milled, casted, set a ton of stones, delivered. Then was told it the design was an exact opposite of hers. Then redid the band for him again at my expense.

Todd


Return to “New Members”

Who is online

Users browsing this forum: No registered users and 2 guests