Welcome to our community. Please introduce yourself.
2 posts • Page 1 of 1
I am doing a one side project. How do i set the 'model top edge depth" in Modela 4? My wax is 5.5 mm deep , the model is 4.4mm deep . Do I subtract the numbers and enter 1.1 for the model top edge depth in the z direction? Thanks.
just mill it and you will have apx 1mm left over on the bottom section or you can enter your numbers as posted ..make sure you have a sacrifical base down if you do.... or you will hit the table with your bit ....
rhino4 and 5, rhino gold, hypershot, vector magic, next engine, cadwax ring builder, tsplines
Who is online
Users browsing this forum: No registered users and 2 guests