THE 3DWAXMILLER CLUB. Forum Index THE 3DWAXMILLER CLUB.
A place to share your experiences with your 3dwaxmill system. 3D Wax Mill
 
 AlbumAlbum FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   RegisterRegister 
 ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 


 The 3dwaxmiller Club Forum Highlights
Check this page often for new and important post.

   The 3dwaxmiller Club Gallery
See Jewelry, Waxes and other project designed and created by our members with the 3dwaxmill.


Rotary Blue Zircon Rg
Pic Title: Rotary Blue Zircon Rg
Pic Description: Here's a piece that I did using my rotary. The ring was designed in 3d engrave with only minimal altering after it was carved. The center bezel was milled seperate and added to the wax.
Poster: JewelryDoctor
Posted: Tue May 03, 2005 12:03 pm
View: 243
Comments: 5
Poster: jeff dunnington @ Tue May 03, 2005 6:15 pm
JD that is awesome!! Looks like you are putting the rotary through the paces. Now we only want to think in the round.

Jeff



 
Poster: Colin Creed @ Wed May 04, 2005 4:16 am
Really interesting design, JD. Well done!!
regards Colin



 
Poster: Erric @ Wed May 04, 2005 2:08 pm
U da man,very nice pc & might I say,cool design.


 
Poster: Jwlrymkr @ Thu May 12, 2005 12:29 pm
Very good job as always JD!
Did you mill bezels under the stones or just holes? It's hard to see from the pic.



 
Poster: JewelryDoctor @ Thu May 12, 2005 2:54 pm
Thanks Ken I milled dimples where the holes should go. I was not sure how it would mill going all the way through.


 
Order:  
Page 1 of 1 All times are GMT - 6 Hours



Powered by phpBB © 2001, 2005 phpBB Group