THE 3DWAXMILLER CLUB. Forum Index THE 3DWAXMILLER CLUB.
A place to share your experiences with your 3dwaxmill system. 3D Wax Mill
 
 AlbumAlbum FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   RegisterRegister 
 ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 


 The 3dwaxmiller Club Forum Highlights
Check this page often for new and important post.

   The 3dwaxmiller Club Gallery
See Jewelry, Waxes and other project designed and created by our members with the 3dwaxmill.


THE 3DWAXMILLER CLUB. Forum Index -> Album -> The 3dwaxmillers Club Gallery Click each picture to enlarge
Pan
Pic Title: Pan
Pic Description: This was a fun one
scanned an old cameo and actually used mod4 to mill
14kt with a 24kt flash a short 3 dwt
Poster: frog113
Posted: Mon Jul 25, 2005 10:10 am
View: 241
Comments: 3
Poster: McCay @ Tue Jul 26, 2005 6:46 am
Nice piece. How long did it take to mill and what are the dimensions?


 
Poster: Colin Creed @ Tue Jul 26, 2005 3:18 pm
Hi Larry,
Interesting piece, Well done!
Beats carving it by hand!!
regards Colin


 
Poster: frog113 @ Wed Jul 27, 2005 4:03 am
forget the time, but over an hour for the final pass
I did mill more of the original cameo than I needed to
and still had to cut the figure out of the wax
haven't been too successful at pulling just the figure out of Dr Picza

Pan is a strong 1 1/4" tall

larry


 
Order:  
Page 1 of 1 All times are GMT - 6 Hours

Powered by Photo Album 2.0.53 © 2002-2003 Smartor


Powered by phpBB © 2001, 2005 phpBB Group