THE 3DWAXMILLER CLUB.
A place to share your experiences with your 3dwaxmill system.
3D Wax Mill
Album
FAQ
Search
Memberlist
Usergroups
Register
Profile
Log in to check your private messages
Log in
The 3dwaxmiller Club Forum Highlights
Check this page often for new and important post.
The 3dwaxmiller Club Gallery
See Jewelry, Waxes and other project designed and created by our members with the 3dwaxmill.
THE 3DWAXMILLER CLUB. Forum Index
->
Album
->
The 3dwaxmillers Club Gallery Click each picture to enlarge
Emerald Cut Dia Band
Pic Title:
Emerald Cut Dia Band
Pic Description:
Needed a ring to fit 5 emerald cuts that were 4.3mm x 3.1mm. Plus needed to be common prong. Milled this with the rotary. Cast in 14k white.
Poster:
JewelryDoctor
Posted:
Tue Aug 09, 2005 5:36 pm
View:
265
Comments:
5
Poster:
McCay
@ Tue Aug 09, 2005 10:22 pm
Nice work... Are you using the same formula for warp as you would for rounds? Very solid looking ring.
McCay
Poster:
Colin Creed
@ Wed Aug 10, 2005 3:35 am
Hi Michael,
What would we do without the mill & rotary.
Would've been a pain doing it as a handmade!
Nice looking piece. Well done!
regards Colin
Poster:
frog113
@ Wed Aug 10, 2005 4:08 am
Looks Great!
Larry
Poster:
Jwlrymkr
@ Fri Aug 12, 2005 10:59 am
Great job Michael!
Ken
Poster:
JewelryDoctor
@ Sat Aug 13, 2005 10:28 am
On this one I used a formula that Jeff is working on. We will get back all the members after a few more experiments. But it is based on a way to add length to the overall relief without altering the shapes. For example on this it was a sz 6. I designed the with the relief at 69mm long instead of 61 which is normal for a 6. We are trying to see if this ratio is consistant for all sizes.
Order:
Ascending
Descending
Page
1
of
1
All times are GMT - 6 Hours
Powered by Photo Album 2.0.53 © 2002-2003
Smartor
Powered by
phpBB
© 2001, 2005 phpBB Group