A place to share your experiences with your 3dwaxmill system. 3D Wax Mill
 AlbumAlbum FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   RegisterRegister 
 ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

 The 3dwaxmiller Club Forum Highlights
Check this page often for new and important post.

   The 3dwaxmiller Club Gallery
See Jewelry, Waxes and other project designed and created by our members with the 3dwaxmill.

Topaz Pendant
Pic Title: Topaz Pendant
Pic Description: This was a large piece. I milled in two parts and then waxed together so that the majority of the middle would be open and hollow to reduce weight. The stones went right in and a little tightening was all it took.
Poster: McCay
Posted: Mon Mar 14, 2005 2:27 pm
View: 288
Comments: 2
Poster: Jwlrymkr @ Mon Mar 14, 2005 5:16 pm
Aint casting soooo much easier than fabrication?
Great work!

Poster: JewelryDoctor @ Mon Mar 14, 2005 6:41 pm
Very nice channel work also. Great job.

Page 1 of 1 All times are GMT - 6 Hours

Powered by phpBB © 2001, 2005 phpBB Group