milled on the 15
Moderator: ToddMichael
milled on the 15
made one like this awhile back and sold it so I'll make another only larger tweeking the wax a little before I cast...two piece assembly gallery
- Attachments
-
- bb.JPG (111.28 KiB) Viewed 17394 times
-
- aa.JPG (80.68 KiB) Viewed 17394 times
rhino4 and 5, rhino gold, hypershot, vector magic, next engine, cadwax ring builder, tsplines
- ToddMichael
- Posts: 623
- Joined: Sat Jun 21, 2008 11:36 am
- Location: Detroit, MI
- Contact:
8ct non calibrated cut .....took me 3x's to get the milled size right for the center!..... anyway here it is so far I still have to order the diamonds as these are just for the picture and too small! ... the center will be set lower with tiny little prongs all the way around and the outer prongs holding the diamonds will be much lower..one thing I dont like when using a tapered bit is that the long (outer) prongs are always tapered I guess I need to learn to go back over with a long reach straight bit...luckey I got this far!
- Attachments
-
- 100_3521.JPG (81.01 KiB) Viewed 17389 times
-
- 100_3518.JPG (166.82 KiB) Viewed 17389 times
-
- 100_3517.JPG (77.61 KiB) Viewed 17389 times
rhino4 and 5, rhino gold, hypershot, vector magic, next engine, cadwax ring builder, tsplines
- ToddMichael
- Posts: 623
- Joined: Sat Jun 21, 2008 11:36 am
- Location: Detroit, MI
- Contact:
- ToddMichael
- Posts: 623
- Joined: Sat Jun 21, 2008 11:36 am
- Location: Detroit, MI
- Contact:
-
- Posts: 1
- Joined: Tue May 20, 2014 4:29 am
Re: milled on the 15
Hey guys,
How do you get that shape? Finding it hell to make different shapes without it being messy. Isn't Cut Studio the way to go?
Khalid
How do you get that shape? Finding it hell to make different shapes without it being messy. Isn't Cut Studio the way to go?
Khalid
Re: milled on the 15
those were designed in rhino and milled on the 15
rhino4 and 5, rhino gold, hypershot, vector magic, next engine, cadwax ring builder, tsplines
- ToddMichael
- Posts: 623
- Joined: Sat Jun 21, 2008 11:36 am
- Location: Detroit, MI
- Contact:
Re: milled on the 15
Schmitty;
Been calling and emailing you, whats the dealio?
Do you have a MDX-15, I thought you had a MDX-540?
Todd Michael
Been calling and emailing you, whats the dealio?
Do you have a MDX-15, I thought you had a MDX-540?
Todd Michael
- jeff dunnington
- Site Admin
- Posts: 1622
- Joined: Tue Feb 24, 2004 1:24 pm
- Location: Houston, Tx
- Contact:
Re: milled on the 15
Khalidyasjewellers wrote:Hey guys,
How do you get that shape? Finding it hell to make different shapes without it being messy. Isn't Cut Studio the way to go?
Khalid
I draw shapes in cutstudio. you can draw poly curves much better. Say I have a unusual stone shape I will aquire scan it on my flatbed scanner into cutstudio, trace it then copy the shape and paste it into 3dengrave. Works great!!