Welcome to our community. Please introduce yourself.
Moderator: ToddMichael
-
Paulie
- Posts: 11
- Joined: Wed Mar 16, 2011 9:06 am
- Location: Port Charlotte, Florida
-
Contact:
Post
by Paulie » Wed Mar 16, 2011 10:57 am
Hi folks, just wanted to stop in and introduce myself......I'm Paul Mosher (Paulie) and I just ordered my 3D Wax Mill. I am looking forward to getting it and getting started creating my own (and others) designs. I know that I will be asking a lot of questions. We have owned a retail jewelry store and jewelry repair center for going on 14 years, and since I retired from Law Enforcement a little over 2 years ago I have been getting bored with the same old routine.....we have a bench jeweler so I don't get much time at the bench (I have a complete set up at the house), so now it's my turn to have some fun and take our store to a new level!!! Take care everyone and have a great day!!!
Paulie
www.jewelrystoreinc.com
Paul Mosher
-
Colin Creed
- Senior Miller
- Posts: 819
- Joined: Tue Jul 20, 2004 2:57 am
- Location: Berwick, Victoria, Australia
-
Contact:
Post
by Colin Creed » Wed Mar 16, 2011 12:39 pm
Hi Paulie & Welcome to the Forum.
regards Colin
-
Paulie
- Posts: 11
- Joined: Wed Mar 16, 2011 9:06 am
- Location: Port Charlotte, Florida
-
Contact:
Post
by Paulie » Thu Mar 17, 2011 1:43 pm
Thanks Colin, looking forward to great things with the mill and great tips and advice from other members of the Mill Club Forum.
Paul Mosher
-
jeff dunnington
- Site Admin
- Posts: 1622
- Joined: Tue Feb 24, 2004 1:24 pm
- Location: Houston, Tx
-
Contact:
Post
by jeff dunnington » Thu Mar 17, 2011 1:58 pm
Paulie
Great to have you as the newest member. I am sure you are anxious to get your mill up and running. Will keep you posted on the delivery date.